![]() ![]() The camera will then drive to the drill hole on the upper right. With the arrow buttons centre the cross hair on the actual position of the drill hole and confirm this position by clicking in the green check sign in the middle of the direction arrows. We recommend to use a drill layer, at best the reference hole file). If now you click on Start at tab Run CNC, the machine will at first move to the position, where it believes to find the drill hole on the utmost lower left (with a routing file the machine will drive to the start point of the vector on the utmost lower left. Load the project into RoutePro 3000 and activate the calibration function in tab General. Only if the camera offset to the spindle is correct you can start to calibrate the pcb. At first you must calibrate the offset between spindle tip and cross hair of the camera. ![]() A possibly needed active usb-extension is not part of delivery.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |